Fertilizer Spreader
The Spyker 220 lb. hopper pattern can be adjusted from 0 to 32' wide via the spread control knob on the dashboard.
This allows you to match the spread width to the spray width so you can spread and spray at the same time.
The standard half spread will cut your fertilizer pattern in half with the flip of a switch.

Spray System
The spray system is configured with three pumps and regulators each supporting its own broadcast spray tip. (Actually three separate spray systems utilizing a common tank). The spray tips are calibrated to deliver the same rate per sq. ft. This allows the operator to select the width of the spray pattern during operation based on the area being treated.

The center spray tip covers a width of sixteen feet.
The two outboard spray tips cover a width of four feet each, one to the left and one to the right, with slight overlap in the center.
This allows for three spray patterns:
1. Sixteen feet from the center tip
2. Eight feet with both outboard tips on
3. Four feet to the right with the right tip on or four feet to the left with the left tip on

Simply select the pattern you require by flipping the on/off switches marked on the dashboard.The SS 220 comes with one set of tips pre-calibrated in first gear (3.5mph) at 39 ounces per 1000 Sq. Ft. The twenty gallon tank covers 65,640 square feet, with the capability of treating 295,680 square feet per hour at 3.5MPH (Actual run time.) That's 6.78 acres per hour!
Other sets of "quick change" spray tips are available at higher
and lower rates up to 1.8 gallons per 1000 square feet.